The installation of rapid roll doors can make the working and storage environment safer. It can not only resist the occurrence of theft, but also play a moisture-proof and waterproof effect on the goods in it. Most factories will also choose to install rapid roll doors. When installing, friends can achieve good installation effects as long as they master the basic steps. The following is a detailed introduction to the installation method of rapid roll doors.
First, friends need to see if the manual chain is in the downward position. The motor motherboard of the rapid roll door must be fixed. Generally speaking, the remote control wiring box must be quickly connected to the motor, and then see if the handle is in an inverted position. After turning the button, you can see how the rolling effect of the door is.
In the second step, you can use the size to measure whether the size between the main board and the sub-board is correct. Generally, you need to use a drill to drill a few holes so that the bearings can be installed properly. The bottom should also be welded as firmly as possible to achieve a good fixing effect.
In the third step, you can put the curtain pieces of the rapid roll door in advance and fix them. Friends should remember to seal them once each one is fixed.
In the fourth step, friends should pay attention to the use of fixed ropes to fix the two sides of the rapid roll door after sealing. At this time, two people are required to operate. One person needs to hold one end of the rapid roll door. The other person turns the curtain to make it rise.
In the fifth step, the control track position of the rapid roll door needs to be opened in a herringbone shape. The rapid roll door should also be adjusted to be flat as much as possible, and the upper and lower lines should be positioned, especially the upper and lower limit positions. When fine-tuning is required, on-site fine-tuning should also be performed.
